Which Error Code

Maytag washer error codes

These are the Maytag washer codes we could verify on the manufacturer's own page. Each block says what the code means, the checks that page allows, and when it says to call a technician.

LF

The washer is taking too long to fill. Also listed as Lo FL, F8 E1. Turn the water on. Open both the hot and cold faucets fully. Maytag says both hot and cold must be supplied. Maytag points to its F8 E1 article for clearing the code. If the faucets are open and LF remains, contact Maytag service. Full page for LF.

Sud

There are excessive suds in the washer. Use HE detergent. Maytag points to its HE detergent guidance. If suds continue with the correct detergent and amount, contact service. Full page for Sud.

Ofb

The load is out of balance. The washer may be running a balance routine. If the dial is flashing and the washer has stopped, redistribute the load, close the lid, and press Start/Pause. Load items in loose heaps evenly around the washplate. Do not wash a single heavy item alone. Add towels. Use Bulky/Sheets Deep Water Wash for comforters or poly filled jackets. Maytag says other items are not right for Bulky/Sheets Normal. If an evenly loaded, level washer keeps stopping, contact service. Full page for Ofb.

lid

The lid was left open. Close the lid. If it stays open more than 10 minutes, Maytag says the cycle resets and the water drains. Start again and do not add more detergent. No parts replacement is indicated for a lid that was simply left open. Full page for lid.

LdL

The lid is not locking. Check for an item directly under the lid, and for detergent buildup around the lid lock. If the lid is clear and LdL remains, contact service.

LdU

The lid cannot unlock. Maytag says the washer detects objects on the lid. Remove objects, such as a laundry basket, from the top of the washer. If the top is clear and LdU remains, contact service.

HC

The hot and cold inlet hoses are reversed. Maytag says the code appears at the end of the cycle. Turn off the water and reverse the hoses. Run another cycle to confirm. This is an installation error, not a failed valve, once the hoses are corrected. Full page for HC.

OL

The load was too large. Maytag says the washer drains the water and detergent. Remove several items, add HE detergent, close the lid, and press Start/Pause. If a smaller load still shows OL, contact service.

PF

The cycle was interrupted by a power failure. Touch and hold Start to restart, or press Power to clear the display. No service call is indicated for a one time power failure.

drn

The washer is not draining properly. Maytag says this can be an installation problem. Check the drain installation in the owner's manual for your model. Maytag's chart does not add a universal hose measurement on this page. If the installation matches the manual and drn remains, contact service.

Frequently asked questions

Where do these Maytag washer codes come from?

Each code on this page is taken from the Maytag support page linked in Sources. We do not add codes from repair blogs or from another brand.

Does LF mean the same thing on every Maytag washer?

No. The manufacturer often says a code applies to some models only, or that the same letters mean something else on another model. Check the manual for your model number.

What should I do before I open a panel on a Maytag washer?

Unplug it or switch off the breaker. If it burns gas, shut the gas supply off before any step the manufacturer did not publish. If you smell gas, leave and call your gas utility.

Sources

Retrieved 16 Nov 2026. Which Error Code is not affiliated with Maytag. Names identify the appliance only.

All Maytag pages · All washer brands · Water filters