Which Error Code

Whirlpool washer error codes

These are the Whirlpool washer codes we could verify on the manufacturer's own page. Each block says what the code means, the checks that page allows, and when it says to call a technician.

F9 E1

Long drain. The washer is taking too long to drain. On some top load displays the same alert is drn. Also listed as drn. The drain hose should not extend more than 4.5 inches into the standpipe or laundry tub. Whirlpool says water can siphon back if it goes farther. Use the U shaped hose form from the installation instructions. Do not tape the drain hose into the pipe. There must be an air gap. On the front load page, the maximum drain height is 96 inches from the bottom of the washer. The top load drn page says the hose end should be higher than 36 inches from the floor. Clean the drain pump filter on models that have one, and clean the small drain holes in the door seal. If F9 E1 or drn remains, Whirlpool says to schedule service. Full page for F9 E1.

F21

Drain time is longer than expected. Also listed as F02. Straighten a kinked drain hose and clear the hose, the drain pipe, or the utility sink. Use the U shaped form. Use only HE detergent. Whirlpool says non HE detergent, or too much detergent, can cause suds that lead to leaking, draining problems, or a poor rinse. Press Pause/Cancel. If that does not clear it, unplug the washer for 5 minutes, plug it back in, reselect the cycle, and press Start. If the code remains after those checks, Whirlpool says to call for service. Full page for F21.

Frequently asked questions

Where do these Whirlpool washer codes come from?

Each code on this page is taken from the Whirlpool support page linked in Sources. We do not add codes from repair blogs or from another brand.

Does F9 E1 mean the same thing on every Whirlpool washer?

No. The manufacturer often says a code applies to some models only, or that the same letters mean something else on another model. Check the manual for your model number.

What should I do before I open a panel on a Whirlpool washer?

Unplug it or switch off the breaker. If it burns gas, shut the gas supply off before any step the manufacturer did not publish. If you smell gas, leave and call your gas utility.

Sources

Retrieved 16 Nov 2026. Which Error Code is not affiliated with Whirlpool. Names identify the appliance only.

All Whirlpool pages · All washer brands · Water filters