Samsung washer code 1E
Meaning: Moisture is where it should not be, or the water level sensor has a problem.
The same manufacturer page also lists LE, 1C, LC, LC1, 1 LC.
Checks the manufacturer publishes
- Look for a leak, including a small one.
- Check that the supply hoses and the drain hose are not kinked. Do not remove the drain hose holder screw.
- Run an empty cycle with no detergent or softener. If suds appear, Samsung says too much detergent or a non HE detergent was used. Keep running empty cycles until the suds stop, then see if the code returns.
When to call a technician
If there are no suds and the code continues, Samsung says to request service.
Frequently asked questions
What does Samsung washer code 1E mean?
Moisture is where it should not be, or the water level sensor has a problem.
What can I check on a Samsung washer showing 1E?
Look for a leak, including a small one. Check that the supply hoses and the drain hose are not kinked. Do not remove the drain hose holder screw. Run an empty cycle with no detergent or softener. If suds appear, Samsung says too much detergent or a non HE detergent was used. Keep running empty cycles until the suds stop, then see if the code returns. Unplug the appliance or switch off its breaker before you move it or open a panel. If it uses gas, shut the gas off before any step the manufacturer did not publish.
When should I call a technician for 1E?
If there are no suds and the code continues, Samsung says to request service.
Sources
Retrieved 16 Nov 2026. Models differ. If your manual defines this code differently, the manual wins. Which Error Code is not affiliated with Samsung.
More Samsung washer codes
- 4C: Water is not entering the washer correctly.
- 4C2: The cold water supply is extremely hot, usually because the supply hoses are swapped.
- 5E: Water is not draining at the correct speed, or it is not draining at all.
- UE: The load is unbalanced. A Ur code means the washer will add water and try to balance the load again. Samsung says Ur is not a fault.
- dE: The door is not detected as closed and locked.
- SUd: The washer detected too many suds. It pauses so the suds can settle, then continues. The code may flash again at the end as a reminder.
All Samsung washer codes · Samsung · Washer brands · Safety notes · All error codes