Samsung washer code 4C
Meaning: Water is not entering the washer correctly.
The same manufacturer page also lists 4E, nF, 1 4C.
Checks the manufacturer publishes
- Match the hot hose to the hot inlet and the cold hose to the cold inlet. Samsung says not to use Flood Safe hoses.
- Open both water valves fully and leave them open while the washer runs.
- Samsung says the drain hose should sit 6 to 8 inches into the drain pipe and should not be kinked. Do not remove the screw that holds the drain hose to the back of the washer. If that holder is missing, Samsung says service is required.
- Unplug the washer or switch off its breaker for 1 minute, then restore power and start a cycle.
- If you check the inlet screens, turn the water valves off first, disconnect the hoses, and clean debris from the screens. Open the valves fully after you reconnect them.
When to call a technician
If the code continues, Samsung says to request service.
Frequently asked questions
What does Samsung washer code 4C mean?
Water is not entering the washer correctly.
What can I check on a Samsung washer showing 4C?
Match the hot hose to the hot inlet and the cold hose to the cold inlet. Samsung says not to use Flood Safe hoses. Open both water valves fully and leave them open while the washer runs. Samsung says the drain hose should sit 6 to 8 inches into the drain pipe and should not be kinked. Do not remove the screw that holds the drain hose to the back of the washer. If that holder is missing, Samsung says service is required. Unplug the washer or switch off its breaker for 1 minute, then restore power and start a cycle. If you check the inlet screens, turn the water valves off first, disconnect the hoses, and clean debris from the screens. Open the valves fully after you reconnect them. Unplug the appliance or switch off its breaker before you move it or open a panel. If it uses gas, shut the gas off before any step the manufacturer did not publish.
When should I call a technician for 4C?
If the code continues, Samsung says to request service.
Sources
Retrieved 16 Nov 2026. Models differ. If your manual defines this code differently, the manual wins. Which Error Code is not affiliated with Samsung.
More Samsung washer codes
- 4C2: The cold water supply is extremely hot, usually because the supply hoses are swapped.
- 5E: Water is not draining at the correct speed, or it is not draining at all.
- UE: The load is unbalanced. A Ur code means the washer will add water and try to balance the load again. Samsung says Ur is not a fault.
- dE: The door is not detected as closed and locked.
- SUd: The washer detected too many suds. It pauses so the suds can settle, then continues. The code may flash again at the end as a reminder.
- 1E: Moisture is where it should not be, or the water level sensor has a problem.
All Samsung washer codes · Samsung · Washer brands · Safety notes · All error codes